2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Intake Air System (Transit Connect)

G13373307Courtesy of FORD MOTOR CO.
Item Number Description
1 - Intake Air
2 - Compressed Air
3 - Exhaust Air
4 - Air Filter
5 - Mass Airflow/Intake Air Temperature (MAF/IAT) Sensor
6 - Crankcase Ventilation Heater
7 - Turbocharger Intake Compressor
8 - Cylinder Head
9 - Turbocharger Exhaust Turbine
10 - Outlet To Exhaust System
11 - Variable Geometry Turbocharger Actuator
12 - Exhaust Manifold
13 - Exhaust Gas Recirculation (EGR) Valve
14 - Exhaust Gas Recirculation (EGR) Cooler Bypass Valve
15 - Exhaust Gas Recirculation (EGR) Cooler
16 - Intake Manifold
17 - Intake Throttle Assembly
18 - Manifold Absolute Pressure (MAP) Sensor
19 - Charge Air Cooler (CAC)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.