2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Particulate Matter Bank 1, Sensor 1 (PM11) Module

The PM11 module monitors the PM11 sensor and controls the PM11 sensor heater element. The PM11 module communicates with the PCM through the controller area network (CAN) to report the presence of particulates in the exhaust gas, indicating a concern with the diesel particulate filter.

The PM11 module consists of a microprocessor, RAM, ROM, EEPROM, and heater driver. The EEPROM stores the module calibration. The heater driver supplies a pulse width modulated (PWM) voltage to the

heater portion of the sensor to clean and regenerate the sensor element. The microprocessor processes all of the inputs from the sensor and communicates the information to the PCM.

The PM11 module is located on the right hand frame rail downstream of the diesel particulate filter.

G09957319Courtesy of FORD MOTOR CO.

Typical PM11 Module 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.