2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Intake Air Temperature (IAT) Sensor

The IAT sensor is a thermistor device in which resistance changes with temperature. The electrical resistance of a thermistor decreases as the temperature increases, and resistance increases as the temperature decreases. The varying resistance affects the voltage drop across the sensor terminals and provides electrical voltage signals to the PCM corresponding to temperature.

The IAT sensor is integrated with the mass airflow (MAF) sensor. The MAF/IAT sensor is located in the intake air tube between the air filter housing and the turbocharger intake. On some vehicles the turbocharger inlet pressure (TCIP) sensor is integrated with the MAF/IAT sensor.

G07432282Courtesy of FORD MOTOR CO.

Typical MAF/IAT Sensor 

G09956833Courtesy of FORD MOTOR CO.

Typical MAF/IAT/TCIP/RHS Sensor 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.