2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Fuel Rail Temperature (FRT) Sensor

The FRT sensor is a thermistor device in which resistance changes with temperature. The electrical resistance of a thermistor decreases as the temperature increases, and resistance increases as the temperature decreases. The varying resistance affects the voltage drop across the sensor terminals and provides electrical voltage signals to the PCM corresponding to temperature.

The sensor is mounted on the high pressure fuel injection pump. The FRT sensor measures the temperature of the fuel at the inlet of the high pressure fuel injection pump and provides a feedback signal to the PCM. The PCM uses the FRT sensor input to command the correct fuel injector timing, the pulse width, and the correct injection control pressure for correct fuel delivery at all speed and load conditions.

G10769067Courtesy of FORD MOTOR CO.

Typical FRT Sensor 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.