2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Fuel Rail Pressure (FRP) Sensor

The fuel pressure sensor is a 3 wire variable capacitance sensor. The FRP sensor is located at the front of the left hand side fuel rail. The PCM supplies a 5 volt reference signal which the FRP sensor uses to produce a linear analog voltage that indicates high fuel pressure. The primary function of the FRP sensor is to provide a feedback signal to the PCM indicating the pressure of the fuel in the fuel rail. The PCM monitors fuel rail pressure as the engine is operating to control fuel pressure. This is a closed loop function which means the PCM continuously monitors and adjusts for ideal fuel rail pressure determined by conditions such as engine load, speed and temperature.

G07432275Courtesy of FORD MOTOR CO.

Typical FRP Sensor 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.