2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Exhaust Pressure (EP) Sensor

The EP sensor is a 3-wire variable capacitance sensor that is supplied a 5.0 volt reference signal by the PCM and returns a linear analog voltage signal that indicates pressure. The sensor voltage input to the PCM increases as the pressure increases.

The EP sensor measures the pressure in the exhaust manifold. The EP sensor signal is used for pressure correlation with the manifold absolute pressure (MAP) sensor and input for exhaust gas recirculation (EGR) valve control.

The EP sensor is located at the left rear of the engine. It is attached to an extension tube from the right hand up pipe going to the turbocharger.

G06054441Courtesy of FORD MOTOR CO.

Typical EP Sensor 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.