2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Crankcase Ventilation Sensor

The crankcase ventilation sensor is a hall effect sensor mounted on the crankcase ventilation hose at the air inlet connection. The crankcase ventilation separator is mounted on the driver side rocker cover, with the crankcase ventilation hose connecting the separator to the crankcase ventilation sensor at the air inlet of the turbocharger. The crankcase ventilation hose on the separator side has a tamper proof connector. The crankcase ventilation sensor monitors the crankcase ventilation hose connection at the air inlet of the turbocharger. The crankcase ventilation sensor signal to the PCM indicates if the crankcase ventilation hose is connected or disconnected.

G09136980Courtesy of FORD MOTOR CO.

Typical Crankcase Ventilation Sensor 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.