2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Camshaft Position (CMP) Sensor

The CMP sensor is a Hall effect sensor that detects the position of the camshaft. The CMP sensor identifies when piston number 1 is on its compression stroke. The PCM calculates the CMP signal and the crankshaft position (CKP) sensor signal to determine the camshaft to crankshaft position for correct fuel injection timing during the compression stroke. The CMP sensor is mounted at the front of the engine block, above the crankshaft pulley.

G07432252Courtesy of FORD MOTOR CO.

Typical CMP Sensor 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.