Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE
Pinpoint Tests AJ: Powertrain Control Module (PCM) Power Relay: Introduction
NOTE:
Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.
This pinpoint test is intended to diagnose the following:
- harness circuits: B+, ISP-R, PCMRC, VPWR and PWRGND
- PCM power relay (12A646)
- PCM (12A650)
| Pin | Circuit |
|---|---|
| 5 | VPWR (Vehicle Power) |
| 2 | PCMRC (PCM Relay Control) |
| 1, 3 | B+ (Battery Positive Voltage) |
| Vehicle | Connector | Pin | Circuit |
|---|---|---|---|
| F-150 | A | 47, 61, 62, 76, 77 67, 68, 69 21 50 |
PWRGND VPWR ISP-R PCMRC |
| Transit Connect | B | 96, 97, 98 101, 102, 103 82 42 |
VPWR ISP-R PCMRC |
| All other vehicles | A | 47, 61, 62, 76, 77 1, 16, 17, 2 21 50 |
PWRGND VPWR ISP-R PCMRC |
| Pin | Circuit |
|---|---|
| 46 | VPWR (Vehicle Power) |
| Pin | Circuit |
|---|---|
| 20 | PCMRC (PCM Relay Control) |
| Pin | Circuit |
|---|---|
| 51 | VPWR (Vehicle Power) |
| 39 | PCMRC (PCM Relay Control) |
| Pin | Circuit |
|---|---|
| 34 | VPWR (Vehicle Power) |
| Pin | Circuit |
|---|---|
| 18 | PCMRC (PCM Relay Control) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
