NOTE: Perform the following steps when programming has resulted in a blank module.

Disconnect the VCM II or VCMM from the DLC and PC.
Launch FDRS and log in.
In the Device Manager window that populates, select CANCEL.
Select the appropriate VIN from the Vehicle Identification menu or use Manual VIN Entry and select GO.
In the Vehicle Communication Device Not Detected window that populates, select CONTINUE. If a Device Explorer window populates, select CANCEL.
After the session has started, reconnect the VCM II/ VCMM to the DLC and the PC. The VCM II/ VCMM icon should turn green in the bottom right corner of the screen. If it does not, troubleshoot the FDRS to VCM II or VCMM connection.
In the Toolbox menu, navigate to the failed module and Download/Run PMI. Follow the on-screen prompts. When asked if the original module is installed, select NO and continue through the installation application.
Once programming has completed, a screen may list additional steps required to complete the programming process. Make sure all applicable steps are followed in order.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Programming: Recovery