Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Column - Overview
The steering column system consists of the following components:
- Steering wheel
- SCCM
- Telescopic and tilt motors (power adjustable steering column)
- Steering column control switch (power adjustable steering column)
The steering column is the mechanical linkage between the steering wheel and the steering gear. The steering wheel is mounted to a shaft which passes through the center of the steering column to the intermediate shaft, which connects to the steering gear. The intermediate shaft and steering column shaft both utilize non-servicable U-joint type couplings.
Vehicles with the manual tilt/telescopic steering column are controlled by a mechanical lever on the underside of the steering column to lock and unlock the steering column. When the lever is pulled down, the steering column can be adjusted up or down and in or out to the desired position. While holding the steering wheel in the desired position, lift the lever up to its original position to lock the steering column in place.
Vehicles equipped with the power tilt/telescopic steering column control the steering column position using the steering column control switch. The steering column can be adjusted up or down and in or out to the desired position. The power tilt/telescopic steering column is also part of the driver memory feature.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
