Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Ford Explorer TimberlineFACTORY OEM SERVICE PROCEDURE
Cylinder Block
WARNING: This page is about a different variant/trim than selected.
| Item | Specification |
|---|---|
| Cylinder bore diameter | 3.362 -3.363 in (85.4 -85.42 mm) |
| Cylinder bore roundness | 0.0004 in (.01 mm) |
| Cylinder bore taper | 0.0005 in (.013 mm) |
| Block main bore roundness | 0.0003 in (.007 mm) |
| Main bearing bore inside diameter | 2.850 -2.851 in (72.402 -72.422 mm) |
| Head gasket surface flatness | Flat within 0.150 mm (0.005 in) overall 0.050 mm (0.001 in) per 150 mm (5.905 in) x 150 mm (5.905 in) 0.025 mm (0.0009 in) per 25 mm (0.98 in) x 25 mm (0.98 in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
