2021 Ford Explorer TimberlineFACTORY OEM SERVICE PROCEDURE

Engine Code Information Label

WARNING: This page is about a different variant/trim than selected.

The engine code information label, located on the rear of the vacuum pump and on the LH valve cover, contains the following:

GFD511053Courtesy of FORD MOTOR COMPANY
Item Description
1 Engine plant
2 Drive type
3 Vehicle line
4 Engine displacement
5 Engine part number
6 Engine build date YYDDD
(DDD=Julian Date [001-365])Β 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.