2021 Ford Explorer TimberlineFACTORY OEM SERVICE PROCEDURE

Section 13 (Engine - 3.0L ECOBOOST): Assembly: Engine

WARNING: This page is about a different variant/trim than selected.

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Special Tool(s) / General Equipment 

GFD510627Courtesy of FORD MOTOR COMPANY
205-153 (T80T-4000-W) Handle
GFD511410Courtesy of FORD MOTOR COMPANY
303-1246 Engine Spreader Bar TKIT-2006UF-FLM TKIT-2006UF-ROW
GFD511375Courtesy of FORD MOTOR COMPANY
303-1247 VCT Spark Plug Tube Seal Remover and Installer TKIT-2006UF-FLM TKIT-2006UF-ROW
GFD511403Courtesy of FORD MOTOR COMPANY
303-1248 Camshaft holding tools TKIT-2006UF-FLM TKIT-2006UF-ROW
GFD511107Courtesy of FORD MOTOR COMPANY
303-1250 Seal Installer, Rear Main TKIT-2006UFFLM
GFD511096Courtesy of FORD MOTOR COMPANY
303-1531 Installer, Front Crank Seal and Damper
GFD511070Courtesy of FORD MOTOR COMPANY
303-1633 Remover, Roller Rocker Follower TKIT-2014D-ROW3 TKIT-2014D-FL_ROW
GFD511411Courtesy of FORD MOTOR COMPANY
303-1634 Lift Eyes (2) TKIT-2014D-ROW3 TKIT-2014D-FL_ROW
GFD511404Courtesy of FORD MOTOR COMPANY
303-1696 Cam Comb Tool Study
GFD511097Courtesy of FORD MOTOR COMPANY
303-335 (T88T-6701-A) Installer, Front Cover Oil Seal TKIT-1988-FLM TKIT-1988-F
Floor Crane
Mounting Stand
Plastic Scraper
Flat-Bladed Screwdriver
Piston Ring Compressor
Vise
Vise Jaw Protectors

Materials 

Name Specification
Motorcraft® High Performance Engine RTV Silicone TA-357 WSE-M4G323-A6
Motorcraft® Silicone Gasket Remover ZC-30-A -
Flange Sealant CU7Z-19B508-A WSS-M2G348-A11
Motorcraft® Metal Surface Prep wipes ZC-31-B -
Motorcraft® Metal Brake Parts cleaner PM-4-A, PM-4-B -
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.