2021 Ford Explorer STFACTORY OEM SERVICE PROCEDURE

Normal Operation and Fault Conditions

WARNING: This page is about a different car, the 2020 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the AWD module sends messages to the ABS module through the GWM over the HS-CAN 2. If the ABS module does not receive these messages within the specified time frame, the ABS module sets DTCs. This can be due to a AWD module failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the AWD module, refer to the Network Message Chart in Description and Operation of the Anti-Lock Brake System (ABS) and Stability Control article.Β 

PPT BX ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U011D:87 Lost Communication With All Wheel Drive Control Module: Missing Message This DTC sets if the ABS module does not receive the powertrain torque status message from the AWD module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.