SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EXPEDITION PLATINUM, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 92 (MODULE CONFIGURATION SYSTEM)GENERAL PROCEDURESMODULE PROGRAMMINGPROGRAMMING
2021 Ford Expedition Platinum, RWD

Module Programming: Programming

2021 Ford Expedition Platinum, RWDSECTION Programming
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not delete the original diagnostic scan tool programming session.
  1. Follow all on-screen instructions carefully, especially any key movements IDS directs to perform. Allow the startup and power down routines to complete.
  2. Follow the on-screen instructions to complete the programming process. If programming errors occur, continue to Step 3. If no programming errors occur, continue to Step  8.
  3. NOTE: Perform the following steps when the module programming procedure has resulted in a blank module.

    Obtain the original IDS used when the programming error occurred during Module Reprogramming or PMI.

  4. Disconnect and reconnect the VCM from the DLC and the IDS.
  5. Start a new IDS session.

    • If the IDS can read the VIN, the IDS will default to the failed session.

    • NOTE: Sessions with failed programming will be highlighted in red. If the original session is not listed, click the Recycling bin icon in the lower left corner of the previous session screen to locate any deleted sessions.

      If the IDS cannot read the VIN, locate the original failed vehicle programming session.

  6. Once the session is loaded, the failed process should resume automatically.
  7. If programming does not resume, proceed to the Module Programming menu and select the process previously attempted, PMI or Module Reprogramming. Follow all on-screen instructions.
  8. When the IDS prompts to select certain parameters, click on ALL parameters listed, including items already highlighted.
  9. Perform any additional programming steps in the order directed by the IDS to complete the programming process.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.