2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Pedestrian Alert Control Module (PACM): Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pin-type retainers and position aside the RH lower instrument panel closeout trim panel.
    GFD560639Courtesy of FORD MOTOR COMPANY
  2. Disconnect the electrical connector.
    GFD560640Courtesy of FORD MOTOR COMPANY
  3. Remove the push pins and the PACM.
GFD560641Courtesy of FORD MOTOR COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.