Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE
General Specifications Secondary Generator
WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Specification |
|---|---|
| 2.7L EcoBoost (if equipped) - 130 amp | |
| Generator amps at 80.6°F (27°C) | 49 amps at 625 rpm (min) to 133 amps at 2, 500 rpm (max) |
| Generator pulley ratio | 2.43:1 |
| Generator pulley replaceable | Yes |
| Generator pulley type | Solid Pulley |
| Voltage regulator type | Electronic internal with generator |
| 3.5L EcoBoost (if equipped) - 130 amp | |
| Generator amps at 80.6°F (27°C) | 49 amps at 625 rpm (min) to 133 amps at 2, 500 rpm (max) |
| Generator pulley ratio | 2.43:1 |
| Generator pulley replaceable | Yes |
| Generator pulley type | One-Way Clutch (OWC) |
| Voltage regulator type | Electronic internal with generator |
| 5.0L Ti-VCT (if equipped) - 130 amp | |
| Generator amps at 80.6°F (27°C) | 57 amps at 625 rpm (min) to 133 amps at 2, 500 rpm (max) |
| Generator pulley ratio | 2.56:1 |
| Generator pulley replaceable | Yes |
| Generator pulley type | Overrunning Alternator Decoupler (OAD) |
| Voltage regulator type | Electronic internal with generator |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.