2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE

General Specifications

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Item  Specification 
Backlash Specifications 
Ring gear backlash 0.204-0.305 mm (0.008-0.012 in)
Clearance Specifications 
Housing spreader adapter thread engagement 12.5 mm (0.500 in)
Maximum differential housing spread 0.762 mm (0.030 in)
Lubricant Fill Level Checks 
Lubricant level 9.56 mm (0.38 in) below bottom of differential housing fill hole
Rotational Torque Ranges 
Pinion bearing torque preload 1.8-3.3 Nm (16-29 lb-in)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.