2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Normal Operation and Fault Conditions

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the APIM sends messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within the allotted time frame, the module sets a DTC. This can be due to an APIM failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the air suspension control module, refer to the Network Message Chart in Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article.Β 

PPT CL ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0253:00 Lost Communication With Accessory Protocol Interface Module: No Sub Type Information This DTC sets in the ABS module when the auto hold switch status message from the APIM is not received in the allotted time.
U0554:86 Invalid Data Received From Accessory Protocol Interface Module: Signal Invalid This DTC sets in the ABS module when the auto hold switch status message from the APIM is received with an invalid value.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.