2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE

Pinpoint Tests Ax: Intake Throttle: Introduction

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, 2018 Ford Transit-150, and 2018 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

  • harness circuits: TACM+, TACM-, TP, SIGRTN and VREF
  • intake throttle actuator (9E926)
  • PCM (12A650)
Fig 1: Intake Throttle Actuator Connector
G12084218Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
F-150 A 2
1
3
4
5
TACM-
TACM+
TP
SIGRTN
VREF
Transit B 4
1
6
2
3
TACM-
TACM+
TP
SIGRTN
VREF
All other vehicles C 2
6
5
3
1
TACM-
TACM+
TP
SIGRTN
VREF
Fig 2: Powertrain Control Module-E (PCM-E) Connector
G12084219Courtesy of FORD MOTOR CO.
Vehicle Connector Pin Circuit
Transit A 44
43
16
TACM-
TACM+
TP
All other vehicles B 44
45
29
TACM-
TACM+
TP
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.