Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE
Diagnostic Tools
Below is an equipment list with corresponding part numbers:
REQUIRED EQUIPMENT:
- Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool with functionality described in Scan Tool Setup And Functionality.
- Vehicle Communication Module (VCM) and Ford Diagnosis and Repair System (FDRS) software with appropriate hardware, or equivalent scan tool with functionality described in Scan Tool Setup And Functionality.
RECOMMENDED EQUIPMENT:
- Evaporative Emission Leak Detector With On Board Nitrogen Generator 218-522C or equivalent.
- Rotunda Vacuum/Pressure Tester 164-R0253 or equivalent. Range 0-101.3 kPa (0-30 in-Hg.) Resolution 3.4 kPa (1 in-Hg.)
- Fuel Pressure Test Kit 310-D009 (D95L-7211 A) or equivalent.
- Fuel Pressure Test Adapter 310-180 or equivalent.
- Digital Multimeter (DMM) FLU77-4 or equivalent.
- Adjustable Ignition Spark Tester THX458 or equivalent.
- Rotunda Test Light SGT27000 or equivalent.
- Fuel Pressure T Adapter (5/16") 310-D251 or equivalent
- Deluxe Noid Lite and Signal Test Light Set AST7898 or equivalent.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.