Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Ford Escape Titanium Plug-In HybridFACTORY OEM SERVICE PROCEDURE
Piston Protrusion Check
For information on Ford Color Coded Illustrations, refer to OEM COLOR CODING
Special Tool(s) / General Equipment
| Dial Indicator |
|---|
Check
- Verify that the cylinder block deck surface and the pistons are clean.
- The piston protrusion is measured in-line front and rear avoiding raised or etched marking.
-
NOTE: Use a commercially available deck bridge such as the Proform® 66797 Magnetic Deck Bridge or equivalent.
- Using the dial indicator and a commercially available deck bridge, position at one of the points on the cylinder block deck surface. Use the General Equipment: Dial Indicator
- Zero the dial indictor on the cylinder block deck surface.
-
NOTE: Only rotate the crankshaft clockwise.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
