2021 Ford Edge STFACTORY OEM SERVICE PROCEDURE

Valve Guide Inner Diameter

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING INFORMATION

Check 

NOTE: Refer to the appropriate Engine System articlefor the specification.
  1. NOTE: Valve guides tend to wear in an hourglass pattern. The ball gauge can be inserted into the combustion chamber side of the valve guide, if necessary.

    • Use a ball gauge to determine the inside diameter of the valve guides in 2 directions at the top, middle and bottom of the valve guide.

    • Measure the ball gauge with a micrometer.

    • If the valve guide is not within specifications, install a new cylinder head assembly.

GFD593274Courtesy of FORD MOTOR COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.