2021 Ford Edge SE, 4WDFACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM)

DTC Description Action
B1315:11 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Ground GO to Pinpoint Test C
B1315:15 Backlighting (Non Reflective Controls) Illumination Output: Circuit Short To Battery or Open If all non-networked illumination sources are inoperative, GO to Pinpoint Test C If all non-networked illumination sources are always on, GO to Pinpoint Test E
B1436:01 Digital Dimmer Switch Input: General Electrical Failure GO to Pinpoint Test A
U1000:00 Solid State Driver Protection Active- Driver Disabled: No Sub Type Information REFER to: Body Control Module (BCM)
U3000:49 Control Module: Internal Electronic Failure REFER to: Body Control Module (BCM)
All other BCM Diagnostic Trouble Codes (DTCs) - REFER to: Body Control Module (BCM)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.