Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD2021EDGE SE, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (ACCELERATION CONTROL - EXHAUST SYSTEM)ACCELERATION CONTROL DTCS
2021 Ford Edge SE, 4WD
Acceleration Control DTCS
2021 Ford Edge SE, 4WDSECTION Acceleration Control DTCS
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| P060D:00 | Internal Control Module Accelerator Pedal Position Performance: No Sub Type Information | GO to Pinpoint Test DK |
| P1575:00 | Pedal Position Out Of Self Test Range: No Sub Type Information | GO to Pinpoint Test DK |
| P2122:00 | Throttle/Pedal Position Sensor/Switch D Circuit Low: No Sub Type Information | GO to Pinpoint Test DK |
| P2123:00 | Throttle/Pedal Position Sensor/Switch D Circuit High: No Sub Type Information | GO to Pinpoint Test DK |
| P2127:00 | Throttle/Pedal Position Sensor/Switch E Circuit Low: No Sub Type Information | GO to Pinpoint Test DK |
| P2128:00 | Throttle/Pedal Position Sensor/Switch E Circuit High: No Sub Type Information | GO to Pinpoint Test DK |
| P2138:00 | Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation: No Sub Type Information | GO to Pinpoint Test DK |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.