2021 Ford Bronco Base, 4D Utility, 2.3L Eng VIN H, Part Time T/Case ControlFACTORY OEM SERVICE PROCEDURE

P0443 - EVAP System Purge Control Valve A Circuit

DTC DESCRIPTION P0443 - EVAP SYSTEM PURGE CONTROL VALVE A CIRCUIT

Description:  This DTC sets when the signal moves outside the minimum or maximum limit for the commanded state.
Possible Causes: 
  • VPWR circuit open
  • EVAPCP circuit open
  • EVAPCP circuit short to ground
  • EVAPCP circuit short to voltage
  • Damaged EVAP purge valve
Diagnostic Aids:  To verify normal function, monitor the EVMV PID or EVAPCP PID and the signal voltage (PCM control side). With the valve closed, the EVMV indicates 0 mA (0% duty cycle for EVAPCP) and voltage approximately equal to battery voltage. When the valve is commanded fully open, EVMV indicates 1,000 mA (100% duty cycle for EVAPCP) and a voltage drop of 3 volts minimum is normal.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test HX.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.