Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Ford Explorer STFACTORY OEM SERVICE PROCEDURE
Transfer Case Clutch Learn
For information on Ford Color Coded Illustrations refer to OEM Color Coding .
Activation
- Update the AWD (all-wheel drive) module to the latest calibration available. Module reprogramming will erase stored transfer case clutch kiss point values and initiate rapid kiss point learn procedure. If no later calibration is available then proceed with process below:
- 1. Key OFF.
- 2. Open driver's side door.
- 3. Close driver's side door.
- 4. Wait 30 seconds.
- 5. Turn key on.
- 6. Wait 5 seconds.
- 7. Repeat steps 1-6 thirty five (35) times.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
