The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
ABS module	760	Yes	Yes	IVD initialization	None
ACCM	7C7	No	No	No	None
ACM	727	Yes	Yes	No	None
APIM	7D0	Yes	Yes	No	Rear camera
AWD module	703	No	No	No	None
BCM	726	Yes	Yes	No	Front/rear tire placard (pressure) Lock feedback horn Mislock horn Perimeter alarm - vehicle doors present Rear camera Remote start - vehicle doors present Remote start enable/disable Trailer outage TRM present
BCMC (BJB)	6F0	Yes	Yes	No	None
BECM	7E4	Yes	Yes	No	None
BECMB	723	Yes	No	No	None
CCM	764	Yes	No	No	None
DCDC	746	No	No	No	None
DDM	740	Yes	Yes	Windows initialization	None
DSM	744	Yes	No	No	None
DSP	783	Yes	No	No	None
GSM	732	No	No	No	None
GWM	716	Yes	Yes	No	None
HUD module	7B2	No	No	No	None
HVAC module	733	Yes	Yes	No	None
IPC	720	Yes	Yes	No	Day/year Digital speedometer Driver Belt-Minder™ Hood ajar warning Intelligent Access (IA) menu Maintenance settings Mid-passenger Belt-Minder MyKey™ speed limiter MyKey volume limit Passenger Belt-Minder Remote start climate settings Driver seat Passenger seat Rear defrost Remote start feature Trailer control (off road package) Trailer lighting Trailer sway
IPMA	706	Yes	Yes	Camera calibration	None
OCS module	765	No	No	OCS module re-zero	None
PACM	750	No	No	No	None
PAM	736	Yes	Yes	No	None
PCM	7E0	Yes	Yes	No	None
PDM	741	Yes	Yes	Windows initialization	None
PSCM	730	Yes	Yes	No	None
RCM	737	Yes	Yes	No	None
RGTM	775	Yes	Yes	No	None
RTM	751	Yes	Yes	No	None
SOBDM (Battery Charging Control Module [BCCM])	7E2	Yes	Yes	No	None
SOBDMC	7E6	Yes	Yes	No	None
SCCM	724	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	BLIS/ CTA enable/disable
SODR	7C6	Yes	Yes	No	BLIS/ CTA enable/disable
TCU	754	Yes	No	No	None
TRM	791	Yes	Yes	No	None
WACM	725	Yes	No	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic