The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
ABS module	760	Yes	Yes	IVD initialization EPB apply and release	None
ACM	727	Yes	Yes	No	None
AHCM	7E3	Yes	No	No	None
APIM	7D0	Yes	No	No	None
AWD module	703	Yes	Yes	No	None
BCM	726	Yes	Yes	Ambient lighting calibration Rear view camera calibration	Autolock enable DRL by auto lamps Remote start enable/disable Perimeter alarm Tire pressure
BECMB	723	Yes	No	No	None
CCM	764	Yes	No	Radar horizontal and vertical alignment calibration	None
DACMC (integrated with ACM)	7D5	Yes	Yes	No	ANC ESE
DC/ DC converter control module (Voltage Quality Module [VQM])	746	Yes	No	No	None
DDM	740	Yes	Yes	Windows initialization	None
DSM	744	Yes	No	No	None
DSP	783	Yes	No	No	None
FCIM	7A7	Yes	Yes	No	None
GSM	732	No	Yes	No	None
GWM	716	Yes	No	No	None
HCM	734	Yes	No	No	None
HSWM	714	Yes	No	No	None
IPC	720	Yes	No	No	None
IPMA	706	Yes	No	Camera calibration	None
IPMB	7B1	Yes	No	Camera calibration	None
OCSM	765	No	No	OCSM re-zero	None
PAM (integrated with BCM)	736	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	Yes	Yes	Misfire Monitor Neutral Profile Correction procedure	None
PDM	741	Yes	Yes	Windows initialization	None
RCM	737	Yes	No	No	None
RGTM	775	Yes	Yes	No	None
RTM	751	Yes	No	No	None
SCCM	724	Yes	No	No	None
SCME	776	Yes	No	No	None
SODL	7C4	Yes	No	No	BLIS/CTA enable/disable Blockage enable/disable
SODR	7C6	Yes	No	No	BLIS/CTA enable/disable Blockage enable/disable
TCU	754	Yes	No	No	None
TRM	791	Yes	No	No	None
WACM	725	Yes	No	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart