2020 Ford Edge STFACTORY OEM SERVICE PROCEDURE

Normal Operation and Fault Conditions

During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.Β 

PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0300:51 Internal Control Module Software Invompatibility: Not Programmed Sets due to incomplete or improper module programming procedures.
U2017:57 Control Module Software #2: Invalid/Incompatible Software Component Sets due to incomplete or improper module programming procedures.
U2017:93 Control Module Software #2: No Operation Sets due to incomplete or improper module programming procedures.
U2024:51 Control Module Cal-Config Data: Not Programmed This DTC is only present when a new ABS module is installed, the ABS module is flashed or the ABS module is reconfigured.
U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information Sets due to incomplete or improper module programming procedures.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.