Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Ford Edge ST-Line, FWDFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module (PCM)
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| P0532 | A/C Refrigerant Pressure Sensor "A" Circuit Low | GO to Pinpoint Test A |
| P0533 | A/C Refrigerant Pressure Sensor "A" Circuit High | GO to Pinpoint Test A |
| P0645 | A/C Clutch Relay Control Circuit | GO to Pinpoint Test B |
| P06A0 | Variable A/C Compressor Control Circuit | GO to Pinpoint Test S |
| P1464 | A/C Demand Out Of Self Test Range | GO to Pinpoint Test H |
| P193E | A/C Clutch Request Signal | GO to Pinpoint Test T |
| P2600 | Coolant Pump "A" Control Circuit/Open | GO to Pinpoint Test R |
| P2601 | Coolant Pump "A" Control Circuit Performance/Stuck Off | GO to Pinpoint Test R |
| P2602 | Coolant Pump "A" Control Circuit Low | GO to Pinpoint Test R |
| P2603 | Coolant Pump "A" Control Circuit High | GO to Pinpoint Test R |
| All Other PCM Diagnostic Trouble Codes (DTCs) | -- | REFER to the appropriate Electronic Engine Controls article. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.