2019 Ford Transit-250 Base, 2D Cab Chassis, 3.2L Eng VIN VFACTORY OEM SERVICE PROCEDURE

DTC P0610 - Control Module Vehicle Options Error

DTC DESCRIPTION P0610 - CONTROL MODULE VEHICLE OPTIONS ERROR

Description:  This DTC sets when a PCM vehicle options error has occurred.
Possible Causes: 
  • Aftermarket performance products
  • PCM reprogramming.
  • Corrupted vehicle identification (VID) data
  • PCM internal software error
Diagnostic Aids:  This DTC sets when the PCM detects various VID data that is out of a specified acceptable range.
Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a Replacement PCM.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.