2018 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE

Seat System DTCS: SCMG

DTC INDEX

DTC Description Action to Take
B146F:00 Back Bladder System Electropneumatic Failure: No Sub Type Information GO to Pinpoint Test T .
B146F:04 Back Bladder System Electropneumatic Failure: System Internal Failure GO to Pinpoint Test T .
B1470:00 Cushion Bladder System Electropneumatic Failure: No Sub Type Information GO to Pinpoint Test T .
B1470:04 Cushion Bladder System Electropneumatic Failure: System Internal Failure GO to Pinpoint Test T .
B1471:11 Multi-Contour Seat Switch Input: Circuit Short To Ground GO to Pinpoint Test T .
B1471:13 Multi-Contour Seat Switch Input: Circuit Open GO to Pinpoint Test T .
B1471:2A Multi-Contour Seat Switch Input: Signal Stuck In Range VERIFY there is no obstruction that may be causing the multi-contour seat switch to be stuck in a certain position. If OK, INSTALL a new seat control switch. REFER to Seat Control Switch -- Front in this information.
B1473:11 Pump Driver: Circuit Short To Ground GO to Pinpoint Test T .
U1000:00 Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information DIAGNOSE any other related Driver Multi-Contour Seat Module [SCMG] DTCs first. CLEAR the DTCs. REPEAT the self-test. If DTC U1000:00 returns. INSTALL a new Driver Multi-Contour Seat Module [SCMG]. REFER to the appropriate information in REMOVAL AND INSTALLATION
U2100:00 Initial Configuration Not Complete: no Sub Type Information
NOTE: This DTC indicates PMI has not been done to a newly installed module or configuration data has been lost.
CARRY OUT Programmable Module Installation(PMI) on the Driver Multi-Contour Seat Module [SCMG]. REFER to Module Configuration . REPEAT the self-test. If PMI is successful, the DTC will not be present.
U3000:49 Control Module: Internal Electronic Failure INSTALL a new Driver Multi-Contour Seat Module [SCMG]. REPEAT the self-test.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.