Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Ford Taurus SHOFACTORY OEM SERVICE PROCEDURE
Torque Specifications
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Charge Air Cooler (CAC) outlet pipe-to-Throttle Body (TB) clamp | 5 | -- | 44 |
| Fuel injection pump bolts | -- | -- | -- |
| Fuel jumper tube bolt | 10 | -- | 89 |
| FPCM nuts | 5 | -- | 44 |
| Fuel rail bolts (3.5L Gasoline Turbocharged Direct Injection (GTDI)) | -- | -- | -- |
| Fuel Rail Pressure (FRP) sensor | 33 | 24 | -- |
| High pressure fuel tube flare nut | -- | -- | -- |
| High pressure fuel tube bracket nut | -- | -- | -- |
| TB bolts (3.5L GTDI) | 10 | -- | 89 |
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.