WARNING: This page is about a different variant/trim than selected.

The charts describe specific module configuration information:

All Modules Except BCM and IPC

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
ACCM	7C7	No	No	No	None
APIM	7D8	Yes	Yes	No	None
ABS module	760	Yes	Yes	ABS bleed Multi-calibration routine Inlet valve calibration Master cylinder isolation calibration IVD initialization	None
ACM	727	Yes	Yes	No	Radio presets
BECM	7E4	Yes	Yes	No	None
DC/ DC converter control module	746	No	Yes	No	None
DDM	740	No	No	No	None
FCIM	7A7	No	No	No	None
GWM	716	Yes	Yes	No	None
GFM (Charge Port Light Ring)	7A3	No	No	No	None
GFM (Electric Vehicle Communication Module [EVCC])	7D2	No	No	No	None
HVAC module	733	Yes	Yes	No	None
OCSM	765	No	No	OCSM re-zero	None
PAM	736	Yes	Yes	No	None
PSCM	730	Yes	Yes	No	None
PCM	7E0	Yes	Yes	No	None
PDM	741	No	No	No	None
RFA module	731	Yes	Yes	No	None
RCM	737	Yes	Yes	No	None
SOBDM	7E2	No	Yes	No	None
SASM	79F	No	No	No	None
SOBDMC/ TCM	7E6	Yes	Yes	No	None
TCU	75C	Yes	Yes	No	None

Body Control Module (BCM) and Instrument Panel Cluster (IPC)

NOTE: The Body Control Module (BCM) and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect both modules. On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Car Configuration Parameters
BCM	726	Yes (through Car Configuration Parameters. Refer to: Body Control Module (BCM) . )	Yes	No	NOTE: Do not change car configuration parameters except those listed below. Seat belt warning (Belt-Minder®)English/MetricLanguageMyKey®Two-stage unlockAutolock/unlockPerimeter alarmTire sizeBattery amperage
IPC	720	Yes	Yes	No

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic