WARNING: This page is about a different car, the 2018 Ford EcoSport. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information.

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
ABS module	760	Yes	Yes	IVD initialization	None
APIM	7D0	Yes	Yes	No	None
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	PATS lock configuration TPMS sensor configuration (training) Electronic steering column lock configuration	Courtesy wipe enable/disable Keypad enable/disable Remote keyless entry frequency configuration Remote keyless entry, two-way Remote start enable/disable Remote start duration Person 1 - 4 Vehicle Limit Remote start-lighting enable Remote start-ignition enable RTM configuration TRM configuration Trailer connect configuration Trailer outage configuration
BECMB	723	Yes	Yes	No	None
Audio DSP	783	Yes	Yes	No	None
GWM	716	Yes	Yes	No	None
HVAC module	733	Yes	Yes	No	Remote start
IPC	720	Yes	Yes	No	Remote start feature enable/disable Remote start Climate settings Driver seat Passenger seat Rear defrost Steering wheel
OCSM	765	No	No	OCS module re-zero	None
PAM	736	Yes	Yes	No	None
PSCM	730 0	Yes	Yes	No	Rack end stop enable
PCM	7E0	Yes	Yes	No	None
RCM	737	Yes	Yes	ABS module initialization (new RCM installation only)	Event data recorder lock status
SODL	7C4	Yes	Yes	No	None
SODR	7C6	Yes	Yes	No	None
SCCM	726	Yes	Yes	No	None
TCU	754	Yes	Yes	No	None
TRM	791	Yes	Yes	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic