2018 Ford Fiesta STFACTORY OEM SERVICE PROCEDURE

Tire Pressure Monitoring System (TPMS)

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

DTC Description Action
B1182:00 Tire Pressure Monitoring System: No Sub Type Information GO to Pinpoint Test A
B1182:55 Tire Pressure Monitoring System: Not Configured GO to Pinpoint Test G
B124D:02 Tire Pressure Sensor: General Signal Failure GO to Pinpoint Test B
B1254:51 Right Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test G
B1255:51 Left Rear (Outside On Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test G
C1A56:51 Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test G
C1A58:51 Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test G
-- All Other BCM Diagnostic Trouble Codes (DTCs) REFER to: Body Control Module (BCM) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.