Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Pd: Event Notification Signal (RCM To Pcm): Fiesta: Notes
Refer to appropriate Supplemental Restraint System in OEM Wiring Diagrams article, for schematic and connector information.
Normal Operation and Fault Conditions
On vehicles equipped with a gas engine, the RCM transmits an event notification signal which communicates fuel cut-off status and SRS deployment status to the PCM. This allows the PCM to initiate fuel cut-off in the event of a crash.
The RCM monitors the event notification signal circuit for the following faults:
- Short to voltage
- Short to ground
- Open circuit
If a fault is detected, the RCM stores DTC B11D8:12 or B11D8:14 in memory. The airbag warning indicator does not illuminate if B11D8:12 or B11D8:14 is set.
PPT P RCM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B11D8:12 | Restraint Event Notification: Circuit Short to Battery | Sets when the RCM senses a short to voltage from the event notification signal circuit for more than 12 seconds. |
| B11D8:14 | Restraint Event Notification: Circuit Short to Ground or Open | Sets when the RCM senses a short to ground or an open from the event notification signal circuit for more than 12 seconds. |
Possible Causes
- Wiring, terminals or connectors
- PCM
- RCM
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
