Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Ford Explorer PlatinumFACTORY OEM SERVICE PROCEDURE
Module Configuration and Parameter Chart
WARNING: This page is about a different car, the 2018 Lincoln Continental. However, it is still accessible from the selected car via links, so may be relevant.
The chart describes specific module configuration information:
| Module Name | Module Address | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Progammable Parameters |
|---|---|---|---|---|---|
| APIM | 7D0 | Yes | Yes | No | None |
| ABS module | 760 | Yes | Yes | IVD initialization EPB Apply and Release calibration Brake system pressure bleed |
None |
| ACM | 727 | Yes | Yes | No | None |
| AWD | 703 | Yes | Yes | Automatic torque configuration | None |
| BECMB | 723 | Yes | No | No | None |
| BCM | 726 | Yes | Yes | Configuration Engine Immobilizer (CEI) configuration (new BCM installation) Battery monitor sensor reset (new BCM installation) Battery reset Customer key programming (minimum 2 keys) LIN device configuration PAM new module initialization (if equipped) TPMS sensor calibration (new BCM installation) |
Approach detection Auto relock Auto unlock Courtesy wipe enable/wipe time DRL configuration DRL by autolamps DRL conditions DRL include parklamps Decklid key switch configuration Door key configuration Fog lamp enable Global open/close Low beam enable Keypad enable Lock feedback light Mislock horn One/two stage unlock Park lock control Passive entry/start Piezo sounder feedback Police dark car Power lock enable Power point maxtime/timeout Rain sensing enable Rear wipe reverse wipe Remote start duration Silent mode Static sequence configuration Tire inflation placard front/rear Trim switch inhibit Welcome mat |
| BCMB (column and pedal control module) | 7B7 | Yes | Yes | No | None |
| CCM | 764 | Yes | Yes | Radar horizontal and vertical alignment calibration | None |
| DSP | 783 | Yes | Yes | No | None |
| DACMC | 7D5 | Yes | Yes | No | None |
| DC/ DC converter control module (Voltage Quality Module [VQM]) | 746 | Yes | Yes | No | None |
| Door latch module-left front (DCME) | 7A2 | Yes | Yes | No | None |
| Door latch module -right front (DCMF) | 762 | Yes | Yes | No | None |
| Door latch module-left rear (DCMG) | 7B3 | Yes | Yes | No | None |
| Door latch module-right rear (DCMH) | 7B4 | Yes | Yes | No | None |
| DDM | 740 | Yes | Yes | Windows initialization | None |
| DSM | 744 | Yes | Yes | No | None |
| FCIM | 7A7 | Yes | Yes | No | None |
| GWM | 716 | Yes | Yes | No | None |
| GSM | 732 | No | Yes | No | None |
| GFM (Remote CD module) | 7A1 | No | Yes | No | None |
| HCM | 734 | Yes | Yes | Leveling Sensor Calibration and Headlamp Aiming | None |
| HUD module (LED display) | 7B2 | No | Yes | No | None |
| HUD module (Driver Information display) | 7B2 | Yes | No | HUD module calibration | None |
| HSWM | 714 | Yes | Yes | No | None |
| IPC | 720 | Yes | Yes | No | Remote start enable/disable Climate settings Driver seat Passenger seat Rear defrost Steering wheel |
| IPMA | 706 | Yes | Yes | Camera calibration | None |
| IPMB | 7B1 | Yes | Yes | 360 Degree View Camera Alignment | None |
| OCS | 765 | No | Yes | OCSM re-zero | None |
| PAM (integrated with BCM) | 736 | Yes | Yes | No | None |
| PSCM | 730 | Yes | Yes | No | None |
| PCM | 7E0 | Yes | Yes | Misfire Monitor Neutral Profile Correction procedure PATS reprogramming (new module installation only) |
None |
| PDM | 741 | Yes | Yes | Windows initialization | None |
| RTM | 751 | Yes | Yes | No | None |
| RACM | 774 | Yes | Yes | No | None |
| RHVAC module | 785 | No | Yes | No | None |
| RGTM | 775 | Yes | Yes | No | None |
| RCM | 737 | Yes | Yes | ABS module initialization SRS prove out |
None |
| Front Passenger Seat Control Module (SCMB) | 7A3 | Yes | Yes | No | None |
| SCME (Integrated with DSM) | 776 | Yes | Yes | No | None |
| Rear Seat Climate Control Module (SCMF) | 777 | Yes | Yes | No | None |
| SCMG | 712 | Yes | Yes | No | None |
| SCMH | 713 | Yes | Yes | No | None |
| LH Rear Multi-Contour Seat Module (SCMC) | 702 | Yes | Yes | No | None |
| RH Rear Multi-Contour Seat Module (SCMD) | 763 | Yes | Yes | No | None |
| SODL | 7C4 | Yes | Yes | No | BLIS enable/disable CTA enable/disable |
| SODR | 7C6 | Yes | Yes | No | BLIS enable/disable CTA enable/disable |
| SASM | 797 | Yes | Yes | Steering Wheel Angle Trim Steering Motor Angle Trim |
None |
| SECM | 7C5 | Yes | Yes | No | None |
| SCCM | 724 | Yes | Yes | No | Courtesy wipe enable/disable |
| TCU | 754 | Yes | Yes | TCU provisioning (module reset or ignition key cycle) | None |
| TRCM | 711 | No | Yes | No | None |
| VDM | 721 | Yes | Yes | No | None |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.