Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Fa: Driver Buckle Sensor: Notes
Refer to appropriate Supplemental Restraint System in OEM Wiring Diagrams article, for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver seatbelt buckle switch circuits for the following faults:
- Open circuit
- Short to voltage
- Short to ground
- Current out of range
- Faulted driver seatbelt buckle switch
If a fault is detected, the RCM stores DTC B0050:11, B0050:12, B0050:13 or B0050:1D in memory and sends a message to the IPC to illuminate the airbag warning indicator.
PPT F RCM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B0050:11 | Driver Seatbelt Sensor: Circuit Short to Ground | Sets when the RCM senses a short to ground on the driver seatbelt buckle switch circuit. |
| B0050:12 | Driver Seatbelt Sensor: Circuit Short to Battery | Sets when the RCM senses a short to voltage on the driver seatbelt buckle switch circuit. |
| B0050:13 | Driver Seatbelt Sensor: Circuit Open | Sets when the RCM senses an open on either driver seatbelt buckle switch circuit. |
| B0050:1D | Driver Seatbelt Sensor: Circuit Current Out of Range | Sets when the RCM senses current out of an acceptable range between the driver seatbelt buckle switch circuits. |
Possible Causes
- Wiring, terminals or connectors
- Driver seatbelt buckle switch
- RCM
Visual Inspection and Diagnostic Pre-checks
- Inspect for a damaged driver seatbelt buckle.
- Inspect for damaged wiring harness(es).
- Inspect for loose or damaged connectors.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.