Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Ford Escape Titanium, FWDFACTORY OEM SERVICE PROCEDURE
Seating System Front
- Description And Operation
- Diagnosis And Testing
- Front Seats
- DTC Charts
- Symptom Chart
- Pinpoint Test(s)
- Pinpoint Test A : The Power Seat Is Inoperative Or Does Not Operate Correctly - Driver, Without Memory
- Pinpoint Test B : The Power Seat Is Inoperative Or Does Not Operate Correctly - Passenger
- Pinpoint Test C : The Power Lumbar Is Inoperative - Driver, Without Memory
- Pinpoint Test D : The Power Lumbar Is Inoperative - Driver, With Memory
- Pinpoint Test E : The Power Lumbar Is Inoperative - Passenger
- Pinpoint Test F : The Memory Seat Does Not Operate Using The Seat Control Switch
- Pinpoint Test G : The Memory Seat Does Not Operate Using The Memory Set Switch
- Pinpoint Test H : Easy Entry/Easy Exit Is Inoperative/Does Not Operate Correctly
- Pinpoint Test I : The Heated Seats Are Inoperative - Driver And Passenger
- Pinpoint Test J : The Heated Seat Is Inoperative/Does Not Operate Correctly - Driver
- Pinpoint Test K : The Heated Seat Is Inoperative/Does Not Operate Correctly - Passenger
- Pinpoint Test L : DTC U0140:00
- Pinpoint Test M : DTC U0199:00
- Front Seats
- Removal And Installation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.