Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Ford Escape Titanium, FWDFACTORY OEM SERVICE PROCEDURE
Abs Module DTC Chart
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0405:41 | Invalid Data Received From Cruise Control Module: General Checksum Failure | This DTC sets when the ABS module receives invalid network data from the CCM. RETRIEVE and REPAIR all non network diagnostic trouble codes (DTCs) in the CCM. |
| U0405:86 | Invalid Data Received From Cruise Control Module: Signal Invalid | This DTC sets when the ABS module receives invalid network data from the CCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the CCM and other modules on the network. |
| U2107:00 | Collision Mitigation By Braking: No Sub Type Information | This DTC sets in the ABS module due to long and too frequent collision mitigation brake requests from the CCM RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the CCM and other modules on the network. |
| U2107:68 | Collision Mitigation By Braking: Event Information | This DTC is set in the ABS module due to a high acceleration value detected that differs from request, which can be caused by an abrupt vehicle stop or module failure. RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) in the CCM and ABS module. |
| U2108:00 | Adaptive Cruise Control: No Sub Type Information | This DTC sets in the ABS module when the module detects driver braking and the CCM does not switch off during the ECU fault monitoring cycle. RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) in the CCM and ABS module. |
| U2108:68 | Adaptive Cruise Control: Event Information | This DTC is set in the ABS module when the module detects over-braking during automated vehicle deceleration. If the vehicle deceleration exceeds the 3.2 m/s threshold, the DTC is stored and the adaptive cruise control is deactivated until the next ignition cycle. RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) in the CCM and ABS module. |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Anti-Lock Brake System (ABS) and Stability Control . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.