The charts describe specific module configuration information:

Module Configuration and Parameter Chart

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
ABS module	760	Yes	Yes	IVD initialization Lateral sensor calibration Longitudinal sensor calibration Pressure sensor calibration Central configuration data parameter learning EPB apply and release routine	None
APIM	7D0	Yes	Yes	No	None
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	No	Remote start enable/disable
CCM	764	Yes	Yes	No	None
DSP	783	Yes	Yes	No	None
DDM	740	Yes	Yes	Window AUTO up/down functionality	None
DSM	744	Yes	Yes	No	None
FCIM	7A7	No	Yes	No	None
FCDIM	7A5	Yes	Yes	No	None
GPSM (if equipped)	701	Yes	Yes	No	None
HCM	734	Yes	Yes	No	None
HUD module	7B2	No	No	No	None
HVAC module	733	Yes	Yes	No	Remote start enable/disable
IPMA	706	Yes	Yes	No	None
IPC	720	Yes	Yes	No	Remote start enable/disable Heated driver seat System enable/disable Climate heater menu Quiet start
OCS	765	No	No	Seat weight sensor re-zero	None
PAM	736	Yes	Yes	No	None
PDM	741	Yes	Yes	Window AUTO up/down functionality	None
PSCM	730	No	No	No	None
PCM	7E0	Yes	Yes	No	None
RGTM	775	Yes	Yes	No	None
RFA module	731	Yes	Yes	No	None
RCM	737	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	None
SODR	7C6	Yes	Yes	No	None
SASM	797	No	No	No	None
TCU module	754	Yes	Yes	No	None
TRM	791	Yes	Yes	No	None

Central Car Configuration - Body Control Module (BCM) and Instrument Panel Cluster (IPC)

NOTE: The Body Control Module (BCM) and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect both modules. On the scan tool, first select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Retrieve the Vehicle Configuration Data. Next select Module Programming > Programmable Parameters > Car Configuration Parameter(s) > Vehicle Configuration > Modify and Reinstate Vehicle Configuration Data. Change parameters as needed.

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Car Configuration Parameters
BCM	726	Yes (through Car Configuration Parameters. Refer to BCM in BODY CONTROL MODULE (BCM) .)	Yes	No	NOTE: Do not change car configuration parameters except those listed below. BLIS® enable/disableLoud speaker quantities (6, 9 or 10)LanguagePark assist cameraPerimeter alarm enable/disableRemote start enable/disableTire sizeTowbarTrailer moduleTrailer stability assist
IPC	720	Yes	Yes	No

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic