Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Ford Edge SportFACTORY OEM SERVICE PROCEDURE
DTC U3000: Control Module
| Failure | Action |
|---|---|
| 41 | INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 42 | INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 46 | INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
| 54 | Using a diagnostic scan tool, CARRY OUT the OCS Reset. FOLLOW all instructions on the diagnostic scan tool. If the OCS Reset was not successful, VERIFY correct installation of the OCS. VERIFY the pressure sensor hose is correctly routed and CORRECT the installation as necessary. REPEAT the self-test. If DTC U3000:54 is still present, INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
