Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE
DTC U0422: Invalid Data Received From Body Control Module: Description
NOTE:
This DTC is reporting a missing or invalid message from another module on the data bus. The module that reports the fault is not the problem module. Do not install a new acronym>RCM as part of the repair unless directed to do so in a pinpoint test.
| Failure | Action |
|---|---|
| 00 | CHECK for additional RCM and BCM DTCs. DIAGNOSE and REPAIR any DTCs that are retrieved. For RCM DTCs, REFER to the RCM - Restraint Control ModuleΒ . For BCM DTC, REFER to: Multifunction Electronic Modules article |
| 81 | CHECK for additional RCM and BCM DTCs. DIAGNOSE and REPAIR any DTCs that are retrieved. For RCM DTCs, REFER to the RCM - Restraint Control ModuleΒ . For BCM DTC, REFER to: Multifunction Electronic Modules article |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
