2018 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE

DTC U3000: Control Module

Failure Action
41 INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article
42 INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article
46 INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article
54 Using a diagnostic scan tool, CARRY OUT the OCS Reset. FOLLOW all instructions on the diagnostic scan tool. If the OCS Reset was not successful, VERIFY correct installation of the OCS. VERIFY the pressure sensor hose is correctly routed and CORRECT the installation as necessary. REPEAT the self-test. If DTC U3000:54 is still present, INSTALL a new OCS sensor. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.