2018 Ford Edge SE, AWDFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (PCM)

DTC INDEX

DTC Description Action
P0532 A/C Refrigerant Pressure Sensor "A" Circuit Low GO to Pinpoint Test A
P0533 A/C Refrigerant Pressure Sensor "A" Circuit High GO to Pinpoint Test A
P0645 A/C Clutch Relay Control Circuit GO to Pinpoint Test B
P06A0 Variable A/C Compressor Control Circuit GO to Pinpoint Test S
P1464 A/C Demand Out Of Self Test Range If the HVAC selector was not powered off, POWER the HVAC off, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the DTC does not return, IGNORE the DTC and continue diagnosing other Diagnostic Trouble Codes (DTCs) or symptoms. If the DTC returns, GO to Pinpoint Test H
P193E A/C Clutch Request Signal GO to Pinpoint Test T
P2600 Coolant Pump "A" Control Circuit/Open GO to Pinpoint Test R
P2601 Coolant Pump "A" Control Circuit Performance/Stuck Off GO to Pinpoint Test R
P2602 Coolant Pump "A" Control Circuit Low GO to Pinpoint Test R
P2603 Coolant Pump "A" Control Circuit High GO to Pinpoint Test R
All Other PCM Diagnostic Trouble Codes (DTCs) -- For 2.0L PCM DTC Chart REFER to: Electronic Engine Controls .
For 2.7L PCM DTC Chart REFER to: Electronic Engine Controls .
For 3.5L PCM DTC Chart REFER to: Electronic Engine Controls .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.