Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Ford Transit Connect XLT, Van CargoFACTORY OEM SERVICE PROCEDURE
Module Configuration and Parameter Chart
WARNING: This page is about a different car, the 2016 Ford Transit Connect. However, it is still accessible from the selected car via links, so may be relevant.
The charts describe specific module configuration information:
Direct Configuration
| Module Name | Module Address | Programmable Module Installation (PMI) Available | Reprogram/Flash Capable | Requires Adaptive Learning or Calibration | Available Progammable Parameters |
|---|---|---|---|---|---|
| APIM | 7D0 | Yes | Yes | No | None |
| APIM (Touchscreen) | 7D0 | Yes | Yes | No | Trailer tow Trailer module |
| ABS module | 760 | Yes | Yes | IVD initialization | None |
| ACM | 727 | Yes | Yes | No | None |
| BCM | 726 | Yes | Yes | No | Battery type Cargo door alarm disable (hinged cargo door) Configurable unlocking (hinged cargo door and sliding doors) |
| DDM | 740 | No | No | No | None |
| FCIM | 7A7 | No | No | No | None |
| FCDIM | 7A5 | Yes | Yes | No | Trailer tow |
| GPSM | 701 | Yes | Yes | No | None |
| HCM | 734 | No | No | No | None |
| HVAC module | 733 | No | No | No | None |
| IPC | 720 | Yes | Yes | No | Display language Digital speedometer |
| IPMB (if equipped) | 7B1 | Yes | Yes | No | Trailer module |
| OCSM | 765 | No | No | OCS re-zero | None |
| PAM | 736 | No | No | No | None |
| PSCM | 730 | No | No | No | None |
| PCM | 7E0 | Yes | Yes | Yes | VIN |
| PDM | 741 | No | No | No | None |
| RCM | 737 | Yes | Yes | No | None |
| SODL | 7C4 | Yes | Yes | No | None |
| SODR | 7C6 | Yes | Yes | No | None |
| SASM | 797 | No | No | No | None |
| TRM (vehicles built before 1/26/14) | 791 | No | No | No | None |
| TRM (vehicles built after 1/26/14) | 791 | Yes | Yes | No | Bad LED configuration LIN bus enable |
Body Control Module (BCM) and Instrument Panel Cluster (IPC) Car Configuration
NOTE:
The BCM and IPC have a unique procedure to set Car Configuration Parameters. Configuration changes made will affect several modules. If the car configuration is changed in the BCM or IPC, an adaptive learning of the car configuration may be required in some modules (such as ABS module or RCM), depending on the changed parameter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.