2017 Ford Transit Connect TitaniumFACTORY OEM SERVICE PROCEDURE

Transmission Fluid Exchange

For information on Ford Color Coded Illustrations refer to OEM Color Coding .

Materials 

Name Specification
Motorcraft ® MERCON ® LV Automatic Transmission Fluid XT-10-QLVC MERCON ® LVWSS-M2C938-A

Draining 

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. Use the Fluid Exchanger to change the fluid.

    Material: Motorcraft ® MERCON ® LV Automatic Transmission Fluid / XT-10-QLVC (MERCON ® LV) (WSS-M2C938-A)

  3. Connect the Fluid Exchanger to the transmission fluid cooler tube after the transmission fluid cooler on the return tube. This will help remove any foreign material trapped in the transmission fluid coolers.
  4. Perform the transmission fluid exchange using the Fluid Exchanger. Follow the manufacturer's instructions included with the machine.
  5. Once the transmission fluid exchange is completed, disconnect the Fluid Exchanger. Reconnect any disconnected transmission fluid cooler tubes.
  6. Check the transmission fluid level. Refer to: Transmission Fluid Level Check .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.